Protect EPK 2K TEX - Nova Aetas Inc.

Epoxy resin based, two component, low-viscosity, solvent-free topcoat material

Color	Ral colors
Storage temperature	+5˚C to +25˚C
Packaging(comp. A + comp B)	18 kg + 2 kg tin buckets
Shelf life(25˚C 55%RH)	12 Months(Unopened)
Consumption	0,3–0,5 kg/m² (paint application) 1,1–1,4 kg/m²/mm (self-levelling coating application)
Density	1,55 ±0,05 gr/cm³
Mixing ratio	9:1 (comp. A : comp. B)
Solid content	%100
Mixture pot life (at 10˚C)	80 minute
Mixture pot life (at 25˚C)	30 – 35 minutes
Adhesion to concrete	>1,5 N/mm²
Hardness (Shore D)	75 – 80 (after 7 days)
Waiting time between layers	8 – 12 hours
Waiting time till light use	12- 24 hours
Full dry time	7 days

EPK 2K TEX is an epoxy resin based, two component, low-viscosity, solvent-free topcoat material that provides orange-peel textured surface.

On concrete and cement based mineral surfaces.
On medium and heavy wear industrial areas such as factories, storage halls, loading ramps etc.
On wet volume areas such as hospitals, laboratories, food industries etc.
On thermal and hydroelectric power plants.
On convention centers, car parks, shopping mall floors as non-slip floor materials.

Existing surface must be clean, dry, flat and free of dirt, dust, oil, wax and mold.
All loose, dusty, cracked, crusted and pre-painted surfaces must be cleaned or scraped.
Component A and B should be mixed for at least 3-4 minutes with the help of a low-speed mixer until a homogeneous mixture is obtained.
The mixture should be consumed within 25-30 minutes.
24 hours after the primer application, the application surface must be roughened by sanding.
In order to achieve the desired thickness on the application surface, the product should be spread with the help of a notched trowel and air should be taken with a spiked roller when the coating reaches the appropriate consistency.
The application should not be performed if the ambient temperature is below 10°C or above 30°C.
Avoid application in rainy and windy weather.
After the completion of the coating, the coating should be protected from water contact for at least 24 hours.
Thinning products should not be used with the product during the application.
Relative humidity should not exceed 80% during the application.

1 file(s) 184.98 KB

Download

Please fill in the form to request product samples or for your inquires and we will get back to you.